can i get a rough breakdown of how/when to add logs to maintain temps?
if i were smoking at 250, started with some coals and a piece of wood, got temp at 250:
1) about when would you add more wood - when temps drop to a certain level or when wood has burned down to embers?
2) after adding new wood, when do you start adjusting dampers to get temps back to 250 - after wood has been burning for a few minutes? a specific time period or kind of fire you are looking for?
3) how much higher do your temps get when a new piece of wood is added?
thanks
maintaining temps/fire?
Moderator: TBBQF Deputies
-
- Rustler
- Posts: 136
- Joined: Sun Jun 14, 2015 10:26 pm
- Contact:
- txsmkmstr
- Bandolero
- Posts: 628
- Joined: Tue Jun 14, 2011 7:13 pm
- Location: TX
- Contact:
Re: maintaining temps/fire?
...
Last edited by txsmkmstr on Thu Jun 18, 2015 7:57 am, edited 1 time in total.
Custom LSG 24x40 - 36" Blackstone - (others - R & O FatGirl, ETSC RK-250, Tejas 1628 - all sold)
- k.a.m.
- Chuck Wagon
- Posts: 3746
- Joined: Mon Jun 25, 2012 6:38 pm
- Contact:
Re: maintaining temps/fire?
I run with my exhaust wide open always. I control my temps with my intake air, this way I am cooking with coals and not flaming logs. Once my cooker is set for the day I rarely adjust the intakes.
Once you learn your cooker and how big a coal base she likes to maintain your desired temps then adding a split at the right time is easy.
Example my cooker likes to run between 245° and 275° with a balance temp around 250°. This cycle is about 45 min. to 60 min. depending on wind and so forth.
To maintain this I add a pre-warmed split when my grate temp hits about 250°, she drops to about 245° then climbs back up to around 275° and we repeat the cycle.
Learning where to catch your cooker on the fall and maintaining a small hot coal base is the key.
I hope this helps.
Once you learn your cooker and how big a coal base she likes to maintain your desired temps then adding a split at the right time is easy.
Example my cooker likes to run between 245° and 275° with a balance temp around 250°. This cycle is about 45 min. to 60 min. depending on wind and so forth.
To maintain this I add a pre-warmed split when my grate temp hits about 250°, she drops to about 245° then climbs back up to around 275° and we repeat the cycle.
Learning where to catch your cooker on the fall and maintaining a small hot coal base is the key.
I hope this helps.
- Gator
- Sheriff
- Posts: 6987
- Joined: Mon Dec 11, 2006 3:53 pm
- Location: Coppell, TX
- Contact:
Re: maintaining temps/fire?
k.a.m. wrote:I run with my exhaust wide open always. I control my temps with my intake air, this way I am cooking with coals and not flaming logs. Once my cooker is set for the day I rarely adjust the intakes.
Once you learn your cooker and how big a coal base she likes to maintain your desired temps then adding a split at the right time is easy.
Example my cooker likes to run between 245° and 275° with a balance temp around 250°. This cycle is about 45 min. to 60 min. depending on wind and so forth.
To maintain this I add a pre-warmed split when my grate temp hits about 250°, she drops to about 245° then climbs back up to around 275° and we repeat the cycle.
Learning where to catch your cooker on the fall and maintaining a small hot coal base is the key.
I hope this helps.
What KAM said. Yup.
Gator
"I won't tolerate rude behavior" - Woodrow F Call
"I won't tolerate rude behavior" - Woodrow F Call
-
- Rustler
- Posts: 136
- Joined: Sun Jun 14, 2015 10:26 pm
- Contact:
Re: maintaining temps/fire?
will having too large of a coal base throw off temps as much as not having enough coal?
i have noticed that on my current offset, the later i get into my cook, the more steady the temps are...i usually start off with a full chimney of coals to start and 2-3 logs, but that sounds like a lot...maybe it's just this smoker is odd like that, too
i have noticed that on my current offset, the later i get into my cook, the more steady the temps are...i usually start off with a full chimney of coals to start and 2-3 logs, but that sounds like a lot...maybe it's just this smoker is odd like that, too
- BluDawg
- Chuck Wagon
- Posts: 3671
- Joined: Fri Jul 10, 2009 9:55 am
- Location: Jonesboro,Tx
- Contact:
Re: maintaining temps/fire?
I'd listen to K.A.M. he learnt that from me
Never met a cow I didn't like with a little salt and pepper.
My Blog: Http://acountryboyeats.blogspot.com
Old Country Over/Under
Webber 22" Performer
ECB
My Blog: Http://acountryboyeats.blogspot.com
Old Country Over/Under
Webber 22" Performer
ECB
- Gator
- Sheriff
- Posts: 6987
- Joined: Mon Dec 11, 2006 3:53 pm
- Location: Coppell, TX
- Contact:
Re: maintaining temps/fire?
BluDawg wrote:I'd listen to K.A.M. he learnt that from me
Gator
"I won't tolerate rude behavior" - Woodrow F Call
"I won't tolerate rude behavior" - Woodrow F Call
- limey
- Deputy
- Posts: 3681
- Joined: Sun May 31, 2009 7:10 pm
- Location: Burleson,Texas
- Contact:
Re: maintaining temps/fire?
I also start of with a full chimney of charcoal or lump and a few split pieces of your preferred wood. Wouldn't worry about the higher temp at the start because of you putting cold meat on the pit, wont hurt a thing, should stabilize after a while. I usually have to add a stick about every 40 or 45 minutes to the fire. Will take a lil getting use to but that is the fun of a stickburner.
How bout some more beans Mr.Taggert? I'd say you've had enough!
R & O Custom Trailer
Weber 22.5 Gold
Weber 22.5 Smoky Mountain
Oklahoma Joe Longhorn Edition
Limey BBQ Co. Competition Team
R & O Custom Trailer
Weber 22.5 Gold
Weber 22.5 Smoky Mountain
Oklahoma Joe Longhorn Edition
Limey BBQ Co. Competition Team
- k.a.m.
- Chuck Wagon
- Posts: 3746
- Joined: Mon Jun 25, 2012 6:38 pm
- Contact:
Re: maintaining temps/fire?
BluDawg wrote:I'd listen to K.A.M. he learnt that from me
Always good for a laugh Dawg.
sinfony78 wrote:will having too large of a coal base throw off temps as much as not having enough coal?
i have noticed that on my current offset, the later i get into my cook, the more steady the temps are...i usually start off with a full chimney of coals to start and 2-3 logs, but that sounds like a lot...maybe it's just this smoker is odd like that, too
I think starting with two logs and a chimney of charcoal is fine. Getting your cooker up to temp and letting your cooker get stable is two different time frames. Just because your grates get up to temp in 30 minutes doesn't mean the chamber is stable because the steal is still cool. My cooker takes about one hour to stabilize, starting with a good coal base. I like to cook between 245° and 275° when I start my cooker I let her climb to about 290° then adjust my intakes and wait for her to start falling, when she is around 275° I put my meat on.
Return to “BBQ Pits - Offset and Vertical Smokers”
Who is online
Users browsing this forum: No registered users and 5 guests