Reverse flow build

Custom manufactured BBQ Pits, Do-it-Yourself projects, parts and ideas.

Moderator: TBBQF Deputies

wvuarmyeng
Pilgrim
Posts: 20
Joined: Sun Oct 30, 2016 1:02 pm
Contact:

Reverse flow build

Postby wvuarmyeng » Tue Dec 26, 2017 7:07 pm

Well finally was able to get ahold of some scrap pipe. Picked up a 60 ft piece. Cut the CC to 52" and the FB to 20" it's .375 wall (3/8ths)

Was thinking of 1 door. Make the top cut, weld hinges then make other cuts. Probably will need a counter weight. The calculator is giving me a stack height of 25" with a 4" pipe, it will be mounted on the side.

Plan on doing two racks, well 1 and a half.

Would 3/8" plate be fine for the RF plate? Or would 1/4" be better

I plan on putting a 2" pipe for a drain at the opposite side of the FB. Also if I can find one add a screw adjustment to keep that end lower. Image

Sent from my SM-N950U using Tapatalk
wvuarmyeng
Pilgrim
Posts: 20
Joined: Sun Oct 30, 2016 1:02 pm
Contact:

Re: Reverse flow build

Postby wvuarmyeng » Wed Dec 27, 2017 7:32 am

Well I was thinking and reading some last night. Im gong to mount the FB on the bottom on the CC to give me a few extra inches of cook space.... hopefully ill be able to start welding in a few weeks. Got some last minute deer hunting to do

Sent from my SM-N950U using Tapatalk

Return to “Custom Built Pits, Build Your Own Pit & Pit Modifications”

Who is online

Users browsing this forum: No registered users and 3 guests