Vertical pit build.
Moderator: TBBQF Deputies
-
- Pilgrim
- Posts: 18
- Joined: Sat May 03, 2014 7:15 pm
- Contact:
Vertical pit build.
First time welder. Bought a 250 gallon tank and did most of my cutting with a saw. Did a lot if learning along the way. Didn't anticipate the doors being so heavy. They sagged pretty good with my custom hinges so went a different route. Sturdy as heck. In the end I think she turned out alright. Not hard on the eyes at all. Going to add a table on the left side tomorrow. Hope y'all like. I have 350 bucks in this pit including all hardware. My budget was 400 so I think I came out alright. Too many things to talk about so if you have any questions fire away. By the way if your looking to build a pit it would have been easier to attach the hinges before totally cutting your doors out. These tanks have a tendency to get out of round when completely cut. Again I'm a beginner. Should have done more researching.
Return to “Custom Built Pits, Build Your Own Pit & Pit Modifications”
Who is online
Users browsing this forum: No registered users and 42 guests