a fat ratio question.

Sausage making and curing meats.

Moderator: TBBQF Deputies

sancho
Rustler
Posts: 121
Joined: Fri Mar 01, 2013 6:59 pm
Contact:

a fat ratio question.

Postby sancho » Fri May 29, 2015 9:46 pm

I made a batch of wild hog sausage today. The smoke was on. The outside texture was on. The color was on. The internal texture was mealy. It was crumbling out of the casing. However, it was a bit greasy too. I added 25% back fat to the hog meat. The hog meat seemed to have a higher than usual fat content to it. That's why I stayed in the 20-25% range. It took unusally long to smoke too. I brought it to 154 IT and at 170 on the smoker that took 7.5 hours. The ambient temp today was close to 80. It usually does that in half the time. There weren't fat blisters on it either. Could it possibly have too much fat? Where did I go wrong?
User avatar
Papa Tom
Deputy
Posts: 5975
Joined: Sat Jun 30, 2007 9:40 am
Location: Oak Point, TX
Contact:

Re: a fat ratio question.

Postby Papa Tom » Fri May 29, 2015 10:47 pm

Sounds to me like too much heat for too long. When you want to smoke sausage you want to keep the temp low like 100°F or even less during the smoke period.
Then after you've reached the desired mahogany color raise the temp to cook bringing the temp up to but not exceed 170°F. For regular pork or beef I wouldn't take it that high maybe 160°F but for wild game (or poultry) I think it probably prudent to go to 170°F.

I know the method I describe here has the meat in the danger zone between 40°F and 140°F for a long time that is why the meat mix must contain curing salt.
I know that it is difficult to smoke sausage on a pit that is why you will see the sausage guys build cold smokers. Folks get a kick out of my cardboard box but it does the job just fine.
Bottom line I doubt very much that you had too much fat in the mix.

Edit I want to add something when you bring the sausage out of the heat you want to cool it rapidly I use a 5 gallon bucket of ice water but you can just spray it with a hose.
tarde venientibus ossa....
User avatar
ChileFarmer
Forum Star
Posts: 6602
Joined: Sun Feb 18, 2007 6:18 pm
Location: Jacksonville,Texas
Contact:

Re: a fat ratio question.

Postby ChileFarmer » Sat May 30, 2015 5:03 pm

No expert, but I agree with Papa Tom. CF :D
OK, get over it, you lost. God bless America

http://s235.photobucket.com/albums/ee175/ChileFarmer" target="_blank
Lots of Sub folders to.

http://curingandsmoking.blogspot.com/" target="_blank
User avatar
jmcrig
Bandolero
Posts: 596
Joined: Sun Jan 10, 2010 10:45 am
Location: Chandler, AZ
Contact:

Re: a fat ratio question.

Postby jmcrig » Mon Jun 01, 2015 10:11 pm

I have to agree with PT. Sounds like the fat rendered out.
Mark Crigler

Return to “Sausage and Cured Meats”

Who is online

Users browsing this forum: No registered users and 1 guest