Page 1 of 1
DFW returning member
Posted: Wed Jan 12, 2022 6:27 pm
by super8mm
I have not done much for the last 5 years but for Christmas my wife got me some Traeger accessories, I told here that was great but I don't have a Traeger. Her response was to go get one, what a deal
I picked a Timberline 1300 up and started putting it together but one of the sockets for a leg was not formed right so I called and asked that if I used longer bolts would that void my warranty and they said don't do it we will send you a new 1300. I got the new one today and got the legs and braces on but now I am trying to figure out how to pick it up and stand it on its legs
Re: DFW returning member
Posted: Wed Jan 12, 2022 7:23 pm
by Rambo
Welcome; I’m confident some of the Traeger guys will see this and offer help
Re: DFW returning member
Posted: Thu Jan 13, 2022 12:01 am
by Norway Joe
Welcome from Norway. Look forward to seeing your posts.
Sent fra min SM-G988B via Tapatalk
Re: DFW returning member
Posted: Thu Jan 13, 2022 8:18 am
by super8mm
Rambo wrote:Welcome; I’m confident some of the Traeger guys will see this and offer help
Thanks Rambo
Re: DFW returning member
Posted: Thu Jan 13, 2022 8:23 am
by super8mm
Norway Joe wrote:Welcome from Norway. Look forward to seeing your posts.
Thank you Norway Joe,
Re: DFW returning member
Posted: Fri Jan 14, 2022 9:04 am
by Papa Tom
As for getting the Traeger to stand up I don't know of and special tricks. I think the answer is to get some muscle help and just lift it.
They are a bit awkward in that the weight is more towards the hopper end. I have assembled several but don't remember it being a big problem.
Maybe someone on the forum here that can lend a hand.
BTW welcome back and enjoy that pellet machine....
Re: DFW returning member
Posted: Fri Jan 14, 2022 9:22 am
by super8mm
Papa Tom wrote:As for getting the Traeger to stand up I don't know of and special tricks. I think the answer is to get some muscle help and just lift it.
They are a bit awkward in that the weight is more towards the hopper end. I have assembled several but don't remember it being a big problem.
Maybe someone on the forum here that can lend a hand.
BTW welcome back and enjoy that pellet machine....
Thanks Papa Tom
Re: DFW returning member
Posted: Sat Jan 15, 2022 3:49 pm
by super8mm
Just finished the burnout.
Re: DFW returning member
Posted: Sat Jan 15, 2022 8:30 pm
by Rambo
super8mm wrote:Just finished the burnout.